Safety Information
Verify Line Voltage Before Usecable ground shall be connected to the groundingImportant Information for the User
Festival has been designed for use with 120 voltsystem of the building, as close to the point ofNOTE: This equipment has been tested and found
AC current. Connection to a line voltage other thancable entry as possible.to comply with the limits for a Class B digital
120 volts can create a safety and fire hazard, andInstallation Locationdevice, pursuant to Part 15 of the FCC Rules.
may damage the unit.The limits are designed to provide reasonable
To assure proper operation and to avoid the
protection against harmful interference in a
If you have any questions about the voltagepotential for safety hazards, place the unit on a
requirements for your specific model or about firm and level surface. When placing the unit on aresidential installation. This equipment generates,
uses and can radiate radio frequency energy
the line voltage in your area, consult your sellingshelf, be certain that the shelf and any mounting
and, if installed and used in accordance with
dealer before plugging the unit into a wall outlet.hardware can support the weight of the product.
the instructions, may cause harmful interference
Do Not Use Extension CordsMake certain that proper space is provided both
to radio communication. However, there is no
To avoid safety hazards, use only the power cordabove and below the unit for ventilation. If thisguarantee that harmful interference will not occur
supplied with your unit. We do not recommend thatproduct will be installed in a cabinet or otherin a particular installation. If this equipment does
extension cords be used with this product.enclosed area, make certain that there is sufficient
cause harmful interference to radio or television
air movement within the cabinet. Under some
As with all electrical devices, do not run powerreception, which can be determined by tuning the
circumstances a fan may be required.
cords under rugs or carpets or place heavy equipment off and on, the user is encouraged to
objects on them. Damaged power cords should Do not place the unit directly on a carpeted surface.try to correct the interference by one or more of
be replaced immediately with cords meetingthe following measures:
Avoid installation in extremely hot or cold locations,
factory specifications.or an area that is exposed to direct sunlight orReorient or relocate the receiving antenna.
Handle the AC Power Cord Gentlyheating equipment.Increase the separation between the equipment
When disconnecting the power cord from an ACand receiver.
Avoid moist or humid locations.
outlet, always pull the plug,never pull the cord.
Do not obstruct the ventilation slots on the top Connect the equipment into an outlet on a circuit
If you do not intend to use the unit for any
of the unit, or place objects directly over them.different from that to which the receiver is connected.
considerable length of time, disconnect the
plug from the AC outlet.CleaningConsult the dealer or an experienced radio/TV
Do Not Open the CabinetWhen the unit gets dirty, wipe it with a clean, soft,technician for help.
dry cloth. If necessary, wipe it with a soft cloth
There are no user serviceable components insideThis device complies with Part 15 of the FCC
dampened with mild soapy water, and then a fresh
this product. Opening the cabinet may present aRules. Operation is subject to the following two
shock hazard, and any modification to the productcloth with clean water. Wipe dry immediately with conditions: 1) this device may not cause harmful
a dry cloth. NEVER use benzene, aerosol cleaners,
will void your warranty. If water or any metal objectinterference, and 2) this device must accept
such as a paper clip, a wire or a staple accidentallythinner, alcohol or any other volatile cleaning agent.interference received, including interference
falls inside the unit, disconnect it from the ACDo not use abrasive cleaners, as they may damagethat may cause undesired operation.
the finish. Avoid spraying insecticide near the unit.
power source immediately and consult anNOTE: Changes or modifications may cause this
authorized service station.Moving the Unit
unit to fail to comply with Part 15 of the FCC
Before moving the unit, be certain to disconnect
CATV or Antenna GroundingRules and may void the userOs authority to
If an outside antenna or a cable system isany interconnection cords with other components,operate the equipment.
and make certain that you disconnect the unit from
connected to this product, be certain that it is
the AC outlet.
grounded to provide some protection against
voltage surges and static charges. Section 810 of
CAUTION
the National Electrical Code, ANSI/NFPA No. 70-RISK OF ELECTRIC SHOCK
DO NOT OPEN
1984, provides information with respect to proper
grounding of the mast and supporting structure,
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,DO NOT REMOVE COVER (OR BACK).
grounding of the lead-in wire to an antennaNO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
discharge unit, size of grounding conductors,
The lightning flash with arrowhead symbol, within The exclamation point within an equilateral triangle
location of antenna discharge unit, connection toan equilateral triangle, is intended to alert the user tois intended to alert the user to the presence of
grounding electrodes and requirements of thethe presence of uninsulated Odangerous voltage� within theimportant operating and maintenance (servicing) instructions
productOs enclosure that may be of sufficient magnitude toin the literature accompanying the appliance.
grounding electrode.constitute a risk of electric shock to persons.
NOTE TO CATV SYSTEM INSTALLER
WARNING:TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
This reminder is provided to call the CATV (Cable
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
TV) system installer's attention to article 820-40
CAUTION: TO PREVENT ELECTRIC SHOCK,MATCH WIDE BLADE OF PLUG TO WIDE SLOT,FULLY INSERT.
of the NEC that provides guidelines for proper
ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES,INRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE
grounding and, in particular, specifies that theCORRESPONDANTE DE LA PRISE ET POUSSER JUSQU�AU FOND.
3 |
ACEC
